Menu
Efficient purification of the breathing air from CO2
The air sucked in by the compressor is passed through the AIRSCRUBBER, thus about 70-75 % of the CO contained in the air is removed.2 absorbed.
In this way, the CO2-content is reduced to about one third to one quarter of the value in the intake air - well below the strict limits of DIN EN 12021:2014, provided that the maximum input concentration is not exceeded.
Without much effort, the AIRSCRUBBER is mounted in the intake hose or intake pipe of the compressor in just a few steps and you're ready to go.
The Airscrubber is especially recommended to clean the finished nitrox mixture after a nitrox membrane system and to remove CO2 to filter out.
Also, when using a nitrox membrane system such as the IDE MG 400/700 or any other membrane system, the AIRSCRUBBER is easily integrated into the suction hose of the high pressure compressor. This way the NITROX produced by the NITROX membrane system is led through the AIRSCRUBBER and the CO2 largely absorbed.
Extremely cost-effective to purchase and economical to operate!
The housing of the AIRSCRUBBER is transparent. This makes it easy to see in good time when the absorber material is saturated and needs to be replaced. The material changes color from blue to purple with increasing saturation. If the Airscrubber is discolored over its entire length or the CO2-values exceed the standard values from DIN 12021:2014, the absorber material must be replaced, but at the latest after a maximum of one and a half years.
The Airscrubber is easy to handle and completely maintenance-free except for changing the absorber material.
The absorber material can be changed in no time without any effort.
Technical data:
CO2-Input concentration: max. 1000 ppmv CO2
CO2-output concentration: approx. 25 - 35 % of the input concentration = max. 350 ppmv CO2 at 1000 ppmv input concentration
Rel. humidity of intake air: 10 to 100 %
Ambient temperature and intake air temperature: +5 to +45 °C
Air flow: 100 - 1000 l/min
Service life: maximum 1.5 years
Dimensions: L x W: 73 x 23 cm; Weight: 8.5 kg
Intake manifold inlet and outlet side: 63 mm
Suitable connection hoses must be ordered separately.
Scope of delivery: AIRSCRUBBER, holder set with rubber insert, mounting material, hose clamps